Ad Sense

Sumo

Ski-doo XM Sleds

  1. Looking for feedback for clutch kits. I'm running a stock set up. Leaning towards the Bikeman Kit. .......and go!...
  2. When idling, sometimes the guage displays a battery light. The sled is a 2015 summit xm non electric start. It idles pretty low so not sure if that...
  3. I was about to install my Avid Drivers and was wondering if I ordered the wrong ones. I am in the process of installing a Backcountry X 9328c...
  4. If skidoo were to bring back the 800xm and market it As an Etec Sport and retail for around the 10g mark They would sell like hot cakes. Just...
  5. 2016 xm 800, cluster shows 4 bars and 50 deg c, but happened a few times today where warm up comes up and limps at 6000 rpm, shut it off and...
  6. Hey Im looking on information on different belts and the compound they are made of vs the pin weights needed to run them and keep them from getting...
  7. My buddy is looking for a QR11 helix to try for his homemade turbo kit. He has posted in the clutching/performance section but this sees more traffic...
  8. Hey guys what's the diameter of the factory xm bars where they clamp into the riser. Ive got a bent set on one machine but I think someone swapped...
  9. Hey guys where would a fella find the linq system latches. Not the side the bolts into the tunnel but the side of the system that's affixed to the...
  10. Has anyone had running problems caused by a mbrp can on a 15 600 etech? I have been getting a bog/ stumble off idle sometimes and cutting out on full...
  11. One of my skies got caught on the ramp backing off the truck on of my last rides out and long story short, I need a new rear bumper. Nothing serious,...
  12. Has anyone installed these on a XM? My cousin had them on his new Gen 4 and the handling of that sled compared to mine was night and day. I'm...
  13. Looking for some feedback... It is a beautiful -25 here in Edmonton, and I am heading to Revelstoke tomorrow for a warm-up & some sledding (I saw...
  14. Is it possible to fix an exhaust probe that had the wires pull out of it? And while we're at it, how can I remove a broken primary clutch bolt that...
  15. Just installed my previously enjoyed MBRP can and when I install the probe the nut gets tight but the probe is still quite loose in there. Anyone...